1 / 3
Volvo Door Light Repair Clip (9151343 9178328)
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
When the clip of the door marker light breaks off on P80 Volvos, you can repair it with this glue-on repair clip 🥳
- Ocena
- 0 / 5
- Polubienia
- 27
- Pobrania
- 114
- Wydruki
- 1
- Wyświetlenia
- 574
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 1) (Komentarze: 3)Remiksy (0)Kolekcje (23)Powiązane
The clips of the red side marking lights in all four doors of P80 series Volvos (V70I, S70) tend to break when you try to remove them to change the light bulbs. Sometimes they even break when slamming the door too much. While the lights are still available to buy, they can be equipped with a new clip to save some money (or time).
Installation remarks
- Remove all remaining pieces of the clip (a small file works well for this job). See second picture.
- Dry fit the repair patch (sounds stupid, but probably a good idea). It should fit snugly on the light.
- Make sure the surface is very clean and free from oils (clean with brake clean, IPA, …).
- Sand the plastic surface of the light in the glueing area as well as the glueing area of the repair patch. A file or sanding paper grit in the range of 80-240 should be fine, use what you have on hand.
- Use a glue that is designed or recommended for plastic applications and has a capability to bridge a little bit of a gap. The repair patch fits snugly, but not perfect. Normal CA super glue might not give lasting results.
- Follow the directions of your glue and possibly use a clamp or zip tie to secure the repair patch in place while the glue fully hardens. This can take up to a couple of days depending on the glue.
Print Settings
- Use a temperature resistant but glue-able filament such as ABS, ASA, PETG, PC(CF), … PA might not be (easily) gluable.
- With three outer perimeters, the important parts of the perimeter are completely filled.
Please consider liking and posting a make if you find this useful 🙂
