1 / 2
Bumper light bar for RGT Rescuer / FTX Outback Tracker — zdjęcie 1
1 / 2

Bumper light bar for RGT Rescuer / FTX Outback Tracker

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A holder for 5 5mm LEDs in the front bumper of the RGT Rescuer LC76 EX86190 and FTX Outback Tracker

Ocena
0 / 5
Polubienia
4
Pobrania
41
Wydruki
0
Wyświetlenia
591
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
RC & Robotics
Licencja
Creative Commons — Attribution — Noncommercial

There is a small panel hiding a spot for a light bar in the front bumper.
It is held in place by a few small plastic pegs that are easy to cut.
The inside of the bumper has 4 screw holes. 4x M3x8 screws should be more than enough to keep the light bar in place.  
You will need to install 5 LEDs in the light bar yourself, don't forget the current limiting resistors.
You can get power from them from the receiver, it has a free channel, or use a Y splitter on a used channel.

Original orientation prints with supports. Can be printed on it's side without supports if your printer can bridge a 50mm gap.

A small clip is included to keep 5MM LEDs in place in the existing light pockets in the front and rear bumper, mounts with a short M2 screw. 

Tagi