Bumper light bar for RGT Rescuer / FTX Outback Tracker
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A holder for 5 5mm LEDs in the front bumper of the RGT Rescuer LC76 EX86190 and FTX Outback Tracker
- Rating
- 0 / 5
- Likes
- 4
- Downloads
- 41
- Makes
- 0
- Views
- 594
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- RC & Robotics
- License
- Creative Commons — Attribution — Noncommercial
There is a small panel hiding a spot for a light bar in the front bumper.
It is held in place by a few small plastic pegs that are easy to cut.
The inside of the bumper has 4 screw holes. 4x M3x8 screws should be more than enough to keep the light bar in place.
You will need to install 5 LEDs in the light bar yourself, don't forget the current limiting resistors.
You can get power from them from the receiver, it has a free channel, or use a Y splitter on a used channel.
Original orientation prints with supports. Can be printed on it's side without supports if your printer can bridge a 50mm gap.
A small clip is included to keep 5MM LEDs in place in the existing light pockets in the front and rear bumper, mounts with a short M2 screw.