Monaco Grand Prix - LED Wall Art

Printing settings:

Please note that the modell need to be printed in 1:1 scale to fit the single and purchased parts.

For scaling reference the height of all parts is 11mm.

The single parts and also the “set”-parts are designed to fit on a 200x200mm printer.

With the flat side down all parts are design with zero support structure needed. For minimal weight use a maximum infill of 40%.

Printing list:

• 1x complete

or

• 1x set01, 1x set02, 1x set03

or

• 11x single parts (part01-part11)

Additional parts needed:

• 3x wooden screw Ø3mm for wall mounting
• 3x suitable dowels for the screws
• 1x LED Stripe Kit (Alternativ for better bending: LED Neon tube)(can be found on Amazon or eBay)
• 1x Silicone square tube (6mm wide)(can be found on eBay); (Alterative: silicone from cartridge)
• Glue
• tools for wall mounting (screwdriver, drill, marking pencil)

Mounting:

After printing all parts you have to glue the parts together. Use the picture “overview” to align the single parts in the correct order.

After completing the gluework you have to mark the holes for the dowels. Place the model on your wall and mark the holes with a pencil.  Create the holes with the drill afterwards.

Insert the dowels into the wall and fix the model with the screws.

Glue down the LED stripe to the bottom of the recess. The outlet on part 7 can be used to manage the cables.

Once the LED strip has been positioned, fixed and checked for function, you can insert the silicone tube into the recess. If the tube is not fitting tight, glue the tube into the recess to prevent him from falling off the wall. As an alternative to the tube you can also use transparent silicon from a cartridge.