Bottle Cap/Kronkorken (TPU)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A bottlecap to prevent your drink of becoming food :) ...I hate insects in my beer.
- Ocena
- 4,75 / 5
- Polubienia
- 55
- Pobrania
- 331
- Wydruki
- 4
- Wyświetlenia
- 992
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor & Garden
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
There are 2 versions of the bottle cap. V2 is a little more solid and grips better than V1. V2 MIGHT be a little too tight for small kids…but that also depends on your choice of material.
Material used:
Filatech FilaFlexible40, blue (prints well, no stringing with Prusa-Profile) and
Recreus Filaflex 82A, orange (lots of stringing when moving from part to part…i didnt completely master the Recreus yet. No problem when printing only one at a time.) for the bottom part of the model
Fillamentum Flexfill 98A for the upper part…for haptic reason. It feels sooo good to plop the cap on your bottle :) (should be harder material than the one used for the lower part, i think a 98A is the best solution and prints pretty well…maybe use 95A, if you got that.)
You can also print it with just 1 filament, but like I said above…haptic reasons.
I you don't know how to do a filament change, you should learn it :) …or check out the .3mf i added.
have fun with it.