1" Scope 20 mil Elevation Insert
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Insert for 1" scope rings to add 20 mil to elevation
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 19
- Wydruki
- 0
- Wyświetlenia
- 118
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Insert for 1" scope rings to add 20 mil to elevation. Insert between underside scope and rings to give extra range to scope. Been using it them for over 6 months on bench and range. Proving to be very stable holding zero without creep. Probably only suitable for low recoil rimfire.
Update: Thought I had about 0.5 mil elevation drift and checked the ring screws which weren't quite tight. Suspect the plastic has compressed a bit over time. Use something better than PLA and occasionally check screws. I wouldn't and you don't need to use this for Benchrest. This is to extend the challenge out to 200 and beyond.