1 / 3
IKEA Skådis Makita DC18RA 18v Battery Charger Mount — zdjęcie 1
1 / 3

IKEA Skådis Makita DC18RA 18v Battery Charger Mount

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Makita DC18RA 18v Battery Charger Mount for IKEA SKÅDIS System

Ocena
0 / 5
Polubienia
18
Pobrania
123
Wydruki
0
Wyświetlenia
901
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Tools
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Makita DC18RA 18v Battery Charger Mount for IKEA SKÅDIS System


This is a Makita DC18RA 18v Battery Charger Mount that attaches to the SKÅDIS pegboard with printed M2.5 T-Nuts from 6d6178. (See their collection of T-Nut mounted parts below.)

The result is parts that hold the charger firmly on the board and allows it to easily slide up and out off the pegs if needed. I've designed the parts to be able to lie flat on the print bed without any supports (really) for a quick clean print. There are a couple of integrated minimal supports for the Right side mount which easily snap off after printing.

BOM:

- 1 x SKÅDIS Makita Battery Charger Mount (these printed parts)
- 4 x printed SKÅDIS T-Nuts (from 6d6178)
- 4 x M2.5 hex nuts (to drop into the printed T-nuts listed above)
- 4 x M2.5 screws
 

Read more about the Skadis T-Nuts Mounting System and check out the Skadis T-Nuts Collection for more Skadis accessories that use T-Nuts.

Tagi