Loop Earplugs Screw-Top Lid Case
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Keep your Loops even safer with a screw-top lid.
- Ocena
- 4,5 / 5
- Polubienia
- 47
- Pobrania
- 352
- Wydruki
- 5
- Wyświetlenia
- 2064
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Audio
- Licencja
- Creative Commons — Attribution — Noncommercial
After my old design came loose in the car, I made a screw-top version so that wouldn't happen again. Works with the OG Loops as well my Engages with the Mutes in. Should work for Experience, etc.
PETG is almost a necessity. It works much more smoothly. YMMV, of course.
Inner case must print with the keychain hole-side at the bottom. It needs minimal supports, and they are a pain to remove from where they anchor at the bottom. I suggest trying it with Organic/Tree supports and see how that goes.
Exterior case prints hole-up.
Prints shown in Prusa PETG, .2, 5 walls, 20% infill. I do not recommend printing them at the same time as PETG is pretty stringy.
As always, so much thanks to jecoffey for the original design and scanning.