1 / 2
Pokeball Cherish Ball
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A special Pokeball model with print-in-place hinge, magnet locks, and a 2.5" interior diameter.
- Ocena
- 5 / 5
- Polubienia
- 47
- Pobrania
- 233
- Wydruki
- 2
- Wyświetlenia
- 1072
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Props
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (12)Wydruki i komentarze (Wydruki: 2) (Komentarze: 2)Remiksy (0)Kolekcje (49)Powiązane
A Cherish Ball, based on my original pokeball model. This model is listed as a remix because due to the new ring geometry and alignment pin locations, these lid and ring parts are not compatible with the originals.
Misc. Info:
- The print-in-place ring mechanism has two versions with different tolerances. Make sure your elephants foot compensation is set properly to prevent the hinge from seizing.
- The loose (original) version has a minimum gap size of 0.3mm, and should work with most printers
- The tight version has a minimum gap size of 0.2mm, and should only be printed if you are confident with your printer's capabilities
- The magnets I used measure 6mm x 1.75mm (6x2 nominal). I got them from amazon: https://www.amazon.com/gp/product/B07KJ9H31P
- Printable alignment pins are included, but you can use machined pins too
- This model will need some painting or multi-material printing to add full color