1 / 2
Pokeball Cherish Ball
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
A special Pokeball model with print-in-place hinge, magnet locks, and a 2.5" interior diameter.
- Rating
- 5 / 5
- Likes
- 47
- Downloads
- 235
- Makes
- 2
- Views
- 1,075
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Props
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
A Cherish Ball, based on my original pokeball model. This model is listed as a remix because due to the new ring geometry and alignment pin locations, these lid and ring parts are not compatible with the originals.
Misc. Info:
- The print-in-place ring mechanism has two versions with different tolerances. Make sure your elephants foot compensation is set properly to prevent the hinge from seizing.
- The loose (original) version has a minimum gap size of 0.3mm, and should work with most printers
- The tight version has a minimum gap size of 0.2mm, and should only be printed if you are confident with your printer's capabilities
- The magnets I used measure 6mm x 1.75mm (6x2 nominal). I got them from amazon: https://www.amazon.com/gp/product/B07KJ9H31P
- Printable alignment pins are included, but you can use machined pins too
- This model will need some painting or multi-material printing to add full color