1 / 4
Runout Sensor for MK8 Extruder 1.75mm (same of Tevo Tarantula) — zdjęcie 1
1 / 4

Runout Sensor for MK8 Extruder 1.75mm (same of Tevo Tarantula)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

A functional Runout Sensor to fits with MK8 Extruder for filament 1.75mm, just print and use it. You need enable it in…

Ocena
0 / 5
Polubienia
5
Pobrania
27
Wydruki
0
Wyświetlenia
142
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

A functional Runout Sensor to fits with MK8 Extruder for filament 1.75mm, just print and use it.

You need enable it in firmware, I used Marlin 1.1.9, My board is MKS Base 1.4, this mainboard came with my Tevo Tarantula.

This changes work to me, maybe it'll not works for you.

Configuration_adv.h

#define ADVANCED_PAUSE_FEATURE // I uncommented this line

Configuration.h

#define FILAMENT_RUNOUT_SENSOR // I uncommented this line #define FIL_RUNOUT_INVERTING true // And set this line to true

pins_RAMPS.h

//#define Z_MAX_PIN 19 // I commented this line #define FIL_RUNOUT_PIN 19 // And changed this from 4 to 19 I needed to change this lines in"pins_RAMPS.h" because inMKS Base 1.4 the pin 4 is not available, so I changed to pin 19 that is the endstop of Z+ this is not in use to me. So if you made this changes you'll need to connect the runout sensor at pin 19 (endstop Z+).

Print Settings

Printer Brand:

TEVO

Printer:

Tarantula

Rafts:

No

Supports:

No

Resolution:

0.2

Infill:

10%

Filament: Unknown PLA Black

Category: 3D Printer Parts

Tagi