Low profile Air Assist Nozzle for Ortur Master 2 20W 2021 fixed focus laser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I saw plenty designs for an air-assist nozzle. None of them have the nozzle so low that it also shields the laser from…
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 60
- Wydruki
- 0
- Wyświetlenia
- 511
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Ideas
- Licencja
- Creative Commons — Attribution
I saw plenty designs for an air-assist nozzle.
None of them have the nozzle so low that it also shields the laser from your eyes.
I ASSUME this will be a lot safer for your eyes when you are working with it turned on in the room.
I still advise to use protective glasses when looking directly at it
Disclaimer: USE AT YOUR OWN RISK. Lasers are cool but can harm you.
I have the 2021 20W fixed focus Ortur Laser Master 2, which has a positioning block to set the correct focus. This nozzle is designed to replace that 30mm focus block; I designed it to be 28mm when inserted fully onto the laser.
Designed at a little over 12mm for a snug fit; you might need to sand a bit.
Air assist opening assumes a 6mm outer diameter tube.
Be sure to test if you have enough airflow before starting a cut.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Doesn't Matter
Supports:
Yes
0.2
Infill:
15%
Filament:
eSun PLA+ White
Notes:
I suggest printing upside down using NO support and placing a custom support block under the main nozzle.
See last photo (bottom view)Else you will get support in the air-hose opening, which you cannot remove.
Cura has a great plugin for this (Custom Supports, by Krasimir Stefanov)
Category: DIY