Top lid/cover for dehumidifyer "Comfee MDDF-20DEN3"
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A simple lid/cover for the opening at the top to prevent dust and small items falling inside the unit.
- Ocena
- 0 / 5
- Polubienia
- 15
- Pobrania
- 49
- Wydruki
- 0
- Wyświetlenia
- 394
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a simple lid/cover for the opening at the top of the dehumidifyer to prevent dust and small items falling into the machine.
The outer dimensions are 270x95mm, so you need a bigger machine than the common 220x220mm printers to print the whole lid in one piece.
For being able to still make and use this lid with a ‘regular’-sized printer, I added a model which is only the half of the lid. So you can print that one twice and then either use them like that or glue them together.
Note:
If you encounter the problem that the lid doesn't rest on the machine completely and that there's a gap in between the whole lid and the top of the machine, check the corners of those middle posts, right at the slots.
When I first printed it, I had the z-seam at those corners and had a bit of bulging corners, which lead to the circumstance that the slot became too narrow and therefore the lid didn't sit in place how it's supposed to. Cleaning off those bulges with a sharp knife solved the issue then.