MT2 Collet Wall Holders
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
MT2 wall mount Collet holders Someone asked if i could make a MT2 version of the R8 collet holder wall mounts, i don't…
- Ocena
- 0 / 5
- Polubienia
- 1
- Pobrania
- 20
- Wydruki
- 0
- Wyświetlenia
- 127
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
MT2 wall mount Collet holders
Someone asked if i could make a MT2 version of the R8 collet holder wall mounts, i don't own any MT2 collets, but i have a couple of MT2 bits for my mini lathe, so i modeled these using the (manky) dead centre i have.
The hole is the proper MT2 taper (1.4307 degrees) and these should hold the collets in a good position, with enough sticking out to grab hold of (can always push them up from underneath too)
I made them with the text 1mm to 12mm, and i've included a blank one that you can put stickers on if you use that weird imperial measurement system :)
Also made one with no mounting holes in the back, so if you are mounting them on pegboard you can drill holes to match, and use a label printer to make text stickers for the sizes.
The holders interlock with other ones i have made.
The screws i use to mount these to the wall are called 'Flange Head Self Tapping Screws'
Print Settings
Printer Brand:
Prusa
Printer:
I3 MK3S
Rafts:
No
Supports:
No
Resolution:
200
Infill:
20
Filament: Cheap PLA PLA Yellow
Category: Machine Tools