1 / 5
The 100 Rod cradle with belt fastener — zdjęcie 1
1 / 5

The 100 Rod cradle with belt fastener

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Rod cradle with belt fastener for The 100 3D printer.

Ocena
0 / 5
Polubienia
9
Pobrania
52
Wydruki
0
Wyświetlenia
361
Oceny
0

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial — Share Alike

Modified the rod cradle and added belt fastener.

ROD CRADLE BELT FASTENER SIDE
Holes for heat inserts or 1 screw for all belts.
My recommendation is to use one 30mm or 35mm screw for both clamps, you may add heat inserts for stability or just use short screws for each clamp but the belt may but to much pressure on the heat insert and rip them out.

 

UPDATE 18/4-24 Added "Rod_cradle_with_belt_fastener_back" model

ROD CRADLE BELT FASTENER BACK

Heat inserts m3 

Use m3x10 screws for the blocks

Have not tested this one on my printer yet but should be working fine.

It should be easier to use this one than the one that claps to the side.

 

UPDATE 26/4-24

After some testing of the strenght of the “Rod_cradle_with_belt_fastener_back” Ive notices that the holes are to big, I will fix this when i

I have time

 

Please leave a like if you like them or comment if there is a problem so I can fix it!

Tagi