120mm Fan solder fume extractor
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Suitable for use with 120mm computer fan to create solder fume extractor, two ways to place
- Ocena
- 4,333 / 5
- Polubienia
- 85
- Pobrania
- 369
- Wydruki
- 3
- Wyświetlenia
- 3090
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
Ideal for making a solder fume extractor using a computer mainframe 120mm fan, two ways of placing it, flat to get closer to small soldered objects.
Theoretically you can use all 12mm computer fans, but I'm not good at making circuit boards, so for the finished product I made I used a USB fan from Pano-mounts, which comes with three speeds for the fan, and best of all comes with its own filters and protective cover, so that I don't need to print the other parts (even though I designed them as well). And it came with the fan screws, but all I needed to do was switch the protective cover in a different order to change the air direction, since originally it was used as a heat sink.
I also made a 100mm/4" Duct Adapters that you can use if you need to connect the exhaust pipe.
If you don't need the exhaust pipe you can print an extra fan fence to keep the fan from hurting you.
You can purchase a 1-3mm Smoke Fume Absorber Filter to filter the smoke, you will need to cut it to a 120mm square and leave the screw holes open. If you don't need the filter you can skip printing the filter cover.
If you use this fan kit from Pano-mounts like I did, then you only need to print the Case Enclosure and Duct Adapters.
Here is the link to where I purchased the fan from Amazon USA, you can also purchase a similar product. They also have fans in their store that can be used directly with AC, which would theoretically work as well.
https://www.amazon.com/Powered-Controller-Receiver-Playstation-Electronics/dp/B0814YW36D?ref_=ast_sto_dp&th=1&psc=1