Tamiya TXT-2 Agrios Stands

Tamiya TXT-2 Agrios Stand

This is a stand for the Tamiya TXT-2 Agrios Monstertruck. The Agrios tires are made from a rather soft compound so they'll quickly develop a flat spot if not moved regularly. This stand lifts the vehicle from the ground to prevent flat tires when your car is parked in your model garage.

Print a pair of either one of these. One for the front axle and one for the rear. Do not mix different heights. The side with the embossed TXT-2 lettering is meant to be readable from the front and the rear.

When placing your monster truck on these stands, the top cutouts help to auto-align the axles with the stand. So it's perfectly balanced and supported, every time.

Agrios Tires

Running the standard Agrios Tires? Then these are the right files for you.

• TXT-2 Agrios Stand (Agrios Wheels, ground).stl: For the original Agrios wheels, lifts the truck just enough so it is barely floating above ground, but enough to protect your rubber.
• TXT-2 Agrios Stand (Agrios Wheels, +5mm).stl: The same, but with 5mm additional ground clearance if you need it.
• TXT-2 Agrios Stand (Agrios Wheels, +10mm).stl: For those who want to fly high, an additional 10mm of ground clearance.

With the wheels floating just above ground they can freely spin when moved by hand. When pulling hard on the throttle expect your TXT-2 to easily jump off of these stands. They're designed for parking, not for stunts.

Clod Buster Tires

If you're running your TXT-2 with the popular Clod Buster Tire mod, you can use these .stl files which accomodate for the larger tires.

• TXT-2 Agrios Stand (Clod Buster Wheels, ground).stl
• TXT-2 Agrios Stand (Clod Buster Wheels, +5mm).stl
• TXT-2 Agrios Stand (Clod Buster Wheels, +10mm).stl

Custom Tire mods supported

Your truck has that unique custom mod with special sized wheels? You can fully customize the stands to fit. OpenSCAD source is included and fully parameterised for remixing and further customisation. Source code is also commented so you should be able to find your way around the functions and variables.

Print Settings

• Printer: Any with at least 100mm print bed. (Fits on a Průša mini, Voron0 or larger)
• Print two to support both axles
• Raft: No
• Support: No
• Ironing: Recommended
• Color change: Supported

Lay flat on the the backside where the “TXT-2” impression is, so you can read the embossed text on the front. This will give you more than enough part strength, good detail of the lettering, and minimal printing time.

If your slicer supports ironing, I recommend turning that on for a super smooth front surface. 

Multicolor print by changing filament is supported as well to get some extra contrast for the letters. Průša Slicer's “Set auto color changes” properly detects this to make setting the layer convenient.

Printed models in the picture were printed on a Průša MK3/S, sliced with Průša Slicer 2.2.2 back in the day at 0.3mm layer height and ironing wasn't yet available in that version.