Smoothest Spool holder with material Insulation
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This is the V2 of the Smoothest spool holder, using the filament bag to protect your material.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 10
- Wydruki
- 0
- Wyświetlenia
- 87
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
This is the V2 of the Smoothest spool holder, using the filament bag to protect your material. Using the bag that comes with your 3D printer filament you can protect it while on the printer from the outside environment. OR leave it on there if you REALLY LIKE the material you are using. To install the bag simply cut a small “X” in the center of the bag and then push each side onto each threaded section, the nuts are to secure it to the spindle holder. to change out spools you unscrew the nut from the mount side, manipulate the bag around the spool and slide it off the holder. To assemble the spindle you must use a short section of filament to use as a homing pin to center the other point to the flat side of the spindle, you may use glue but i encourage you to test it and see what works best for you!