Cascade Card Wallet V2 Remix (Print-in-parts)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Remixed so that parts can be printed flat on the print bed, and assembled without any fasteners.
- Ocena
- 5 / 5
- Polubienia
- 17
- Pobrania
- 78
- Wydruki
- 1
- Wyświetlenia
- 825
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Important
• Model has zero tolerance, I wanted to avoid use of glue or screws so that it's very easy to put together (you might have to use pliers or something similar).
• Make sure to set up wall ordering outside to inside, so far I haven't had issues with parts not fitting.
Thanks to @MartinSturm_2137239 here's an important step that was missing:
Parts shown below are bridged so that they are relatively easy to be let loose (apply some force, tho too much and you just might snap them off when they come loose).
They keep the cards in, while letting them through when needed (the most important part of the wallet (not mentioned anywhere of course)).
Advice
When printing the front plate rotate the part so that the bridging is done with the shortest route. (In my case I could only achieve the right rotation by setting Z to -90)
Increase Bottom Layers just enough to get to bridge layer, helps with bridging.
Note: This time around I've excluded the money strap, while it held the money and did its job it was also kind of inconvenient, + just looked weird in the pocket.
Note 2: I used tinkercad website for the cat print, at the depth of 0.6mm (wall is 3mm thick).