Tesla lift aligner
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Just a rubber puck holder to align the lift points and avoid iron on iron contact for emergency lift.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 46
- Wydruki
- 1
- Wyświetlenia
- 972
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
This is a blend of lift pads to be printed with TPU for enough deformation strenght. Designed it for emergency lift (ex: flat tire). They are quick to print and will align the jack's puck at the right place for lifting a tesla. Not designed to support the car, only designed to align the puck and avoid iron on iron lifting! I don't recommand to go under the car with those 3D printed parts but it is safe enough for tire change.
5 walls, 6 top and 6 bottom with 60% linear infill. A litlle oversize ring is there to hold the aligner in place under the car, as shown on one picture. Screw holes already designed if you want to screw a hockey puck on it.
Will fit on a hockey puck and hold the puck in place for a better jack alignment under the car.
The other design must be printed in 2 parts to fit a regular jack, you might need to roll on a block of wood or over a concrete step if you dont have a low porifle jack for the car. Tesla are low profile.