Goodman handle for Sofirn SD01
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A Goodman handle for Sofirn SD01(Pro) dive light with an optional camera mount.
- Ocena
- 5 / 5
- Polubienia
- 14
- Pobrania
- 184
- Wydruki
- 3
- Wyświetlenia
- 1784
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Sports
- Licencja
- Creative Commons — Attribution — Share Alike
I wanted to give a try to the Goodman handle concept so I designed one to go with my new Sofirn SD01Pro dive light. Also, having a GoPro like camera I added a foldable arm to be able to jump into water with the light (and camera) hanging neatly on a D-ring. When the arm is fully folded out, the camera's field of view is more or less aligned with the center of the light beam.
The SD01's beam is quite narrow, so I also designed a diffuser to spread it a bit. The diffuser is very much a work in progress. The slots used to hold the diffuser are slim and the clamps tend to get easily damaged. But it is usable.
There are three sizes that fit my wife's and my hands. Of each size, there are variants for left or right hand and a version without a camera mount.
- 85mm fits my wife's hand in wet gloves
- 95mm fits me with wet gloves and my wife with dry gloves
- 105mm fits me with dry gloves
The handle is designed for two M5x25 stainless steel hex bolts and two M5 washers (OD at least 17mm). Another two M5x25 bolts are needed for the camera arm.
All holes for bolts need to be tapped.
I stretched a rubber sleeve over the end of the light where the camera touches the body when folded to protect the plastic of the camera enclosure. A strip of bicycle tire inner tube works nicely.
There are sharp edges on the inner side of the lanyard holes on the body of the light. Use a file to dull them before attaching the bolt snap!
Print instructions
PETG is advisable to help it survive summer days in a car. I used Fiberlogy PETG, because it seems to be a bit more flexible and less prone to cracking on impact than some other brands I have used. They also sell refills without a spool.
Grip: 0.2mm layers, 5 perimeters, 15% infill, no supports, a little cleanup may be required for overhangs in the slots
Mount, Arm: 0.2mm layers, 3 perimeters, 15% infill, no supports
Thumbnuts: 0.2mm layers, 2 perimeters, 15% infill, 5 bottom layers (to make the part under the head solid), no supports
Diffuser: clear filament (obviously), 0.3mm layers, 15% infill, no supports