Lid supporter for Creality K1/K1C Hinged Lid Raiser
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Add-on to the popular K1/K1C hinged lid raiser to stablise the open lid during printing
- Ocena
- 5 / 5
- Polubienia
- 139
- Pobrania
- 1395
- Wydruki
- 10
- Wyświetlenia
- 7342
- Oceny
- 10
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
If you are using the Creality K1/K1C Hinged Lid Riser and need to keep the lid open while printing some materials (e.g., PLA), do you feel that the opened lid is wobbling/ shaking a little too much during prints?
Look no further.
This add-on for the Creality K1/K1C Hinged Lid Riser allows the opened lid to rest on the printer's frame. As a result, the opened lid is a lot more stable during 3D printing.
This add-on attaches to the rear hinged corners using a set of longer pins. No super-glue or screws needed.
It also works for JC-Creality K1 Hinged Lid Riser.
Change Log
- 21 Apr 2024 - Version 2. Updated design as the bowden tube squishing (slightly) at the right corner (where the filament sensor is). Added corners/ edges.
- 21 Apr 2024 - Version 1
You will need to print
- 2 x Lid Supporter
- 2 x holding pin
How I printed it
- Material: PLA
- Layer height: 0.20mm
- Perimeter: 5 walls
- Top and bottom: 3 walls
- Fill: 30%
- Fill pattern: Grid
- Support: None