FLSUN SR pillar cover with 50mm ring light
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Pillar cover using a 50mm ring with 12 neopixels
- Ocena
- 0 / 5
- Polubienia
- 3
- Pobrania
- 22
- Wydruki
- 0
- Wyświetlenia
- 162
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial
A pillar cover to use 50mm neopixel ring light.
Parts needed:
2x 50mm neopixel ring lights
4x M2x6 self tapping screws
wiring (I used some extra motor cables I had laying around)
optional 2x JST-XH-4A connectors for the lights
Klipper config using MKS Robin Nano v3 with the lights plugged into the 5v and TX3 pins.
[neopixel lights]
pin: PB10
# The pin connected to the neopixel. This parameter must be
# provided.
chain_count: 24
# The number of Neopixel chips that are "daisy chained" to the
# provided pin. The default is 1 (which indicates only a single
# Neopixel is connected to the pin).
color_order: GRB
# Set the pixel order required by the LED hardware (using a string
# containing the letters R, G, B, W with W optional). Alternatively,
# this may be a comma separated list of pixel orders - one for each
# LED in the chain. The default is GRB.
initial_RED: 0.0
initial_GREEN: 0.0
initial_BLUE: 0.0
#initial_WHITE: 0.0
# See the "led" section for information on these parameters.