Sonoff Motion Sensor SNZB-03 Corner Mount
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Corner mount for Sonoff SNZB-03 motion sensor, decline angle of 30°. Mounted with double-sided tape. No support needed.
- Ocena
- 0 / 5
- Polubienia
- 8
- Pobrania
- 79
- Wydruki
- 0
- Wyświetlenia
- 354
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial
Corner mount for Sonoff SNZB-03 motion sensor with a decline angle of 30°. Mounted with double-sided tape.
Designed to fit snugly around the sensor. When not mounted to a wall the sensor can slide in and out sideways. If the fitment needs adjusting it's possible to carefully heat the part with a heat gun and adjust it.
The shown part does not have a hole for the paring button but files for both with and without the hole are available. G-files for for a faster print with only a 2 layer perimeter are also available.
Pint Settings
Material:
PLA
Infill:
10%, Honeycomb
Layer height:
0.15mm, higher layer height will probably work fine
Outer Perimeters:
4 layers, 2 layers will probably work fine
Supports:
No