1 / 4
Corrugated sheet spacer
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Spacer for corrugated sheets (roof)
- Ocena
- 0 / 5
- Polubienia
- 6
- Pobrania
- 79
- Wydruki
- 0
- Wyświetlenia
- 392
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Mechanical Parts
- Licencja
- Creative Commons — Attribution — Share Alike
A spacer for corrugated roofs
height: 21 mm
width: 42 mm
depth: 25 mm
diameter: 40 mm
I just needed three more spacers and did not want to buy 50 at the DIY store.
After it was finished I found a few spare ones in an abandoned drawer…
Printed in PETG, because it gets quite hot on a roof. It is meant to be used with plastics corrugated sheet roof tiles.
The first try failed, I had activated brim, but the shear forces during printing were too much and it was torn off the plate halfway through printing. With the organic supports attached at a few places it worked.