Ground Anchor Driving Nut
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This ground anchor driving nut makes it easier to drive anchors into the ground for swingsets or trampolines
- Ocena
- 0 / 5
- Polubienia
- 4
- Pobrania
- 18
- Wydruki
- 0
- Wyświetlenia
- 150
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution
This ground anchor driving nut makes it easier to drive anchors into the ground for swingsets or trampolines.
I was having difficulty installing ground anchors for my children's swingset. It was difficult to install by hand into the hard ground. I designed this to make it easier to install and remove ground anchors. It uses a 1" nut on one side so you will need a 1" socket. I found using a drill is better than a driver, as the driver can be hard on the printed piece. I start the anchor through the grass by hand and then use the nut to drive it in the rest of the way. I have used 20+ times now without it breaking.
It worked for these anchors, but I suspect it will work for others that look like this: https://a.co/d/ekIflfu
I recommend printing at 100% infill and I used 0.8mm nozzle to get a 0.32mm layer height. I printed in PLA+ and it is holding up so far.
Check out our website: www.mcmaker3d.com