Bissell Crosswave Pet Pro Part Drying Rack
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
A wall mounted rack to store your waste tank parts to dry.
- Ocena
- 0 / 5
- Polubienia
- 11
- Pobrania
- 73
- Wydruki
- 0
- Wyświetlenia
- 618
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other House Equipment
- Licencja
- Creative Commons — Attribution — Noncommercial
If you own a vac mop cleaner for carpets or hardwood you know that drying the waste tank out helps keep it from getting funky. I recently purchased a Bissell Crosswave Pet Pro and wanted to keep it as fresh as possible by allowing the waste tank and parts to dry after cleaning. I didn't want to have them lying around in the way so i designed a 2 part wall mount to hang the parts on and let them dry out.
I printed these on an Ender 3 V3 KE. The parts holder piece needs to be turned 45 degrees to fit on the build plate. I designed this with the idea of joining these together with M3 heat press inserts. it can also be glued. The purpose is to keep it secured to the mounting plate.
The mounting plate has 2 countersunk holes for screwing into the wall. Mount the wall plate so the chamfered extension is on the bottom to give the rack extra support. Stick it in a stud or use drywall mount fittings. You'll figure it out! The rack and all the parts don't weigh a lot.
Parts Needed
M3 heat inserts - 3ea
M3 30mm Screws - 3ea
Wall Mounting Hardware - Your choice.
I printed this in some old PETG I had lying around. PLA would probably work fine because the only thing touching it should be a little water.
No supports needed.
I printed with 4 outer walls for extra support.