Grab Handle Plug for Hyundai Kona N
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This part plugs the hole left in the headliner if you remove the grab handles.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 31
- Wydruki
- 0
- Wyświetlenia
- 421
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Automotive
- Licencja
- Creative Commons — Attribution — Noncommercial
I removed the grab handle from the driver's side of my Kona N because it hit my helmet when autocrossing the car. This left two ugly holes in the headliner. This piece plugs the holes. I only tested this on the Kona N, but I think the handle is a standard Hyundai part, so it will probably work on other Konas and Hyundais.
Print it with the flat side down, no support needed. I used Eco-ABS with 0.1mm layers and 100% infill on a Dremel 3D45, because my Prusas were busy. But I think a wide range of printers, materials, and settings would work.
You will need two flathead screws, M6 x 16mm. This matches the exposed thread length on the original grab handle fasteners. You could probably use a screw as short as 8 or 10 mm and still make it work.