Grab Handle Plug for Hyundai Kona N
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
This part plugs the hole left in the headliner if you remove the grab handles.
- Rating
- 0 / 5
- Likes
- 2
- Downloads
- 31
- Makes
- 0
- Views
- 419
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Automotive
- License
- Creative Commons — Attribution — Noncommercial
I removed the grab handle from the driver's side of my Kona N because it hit my helmet when autocrossing the car. This left two ugly holes in the headliner. This piece plugs the holes. I only tested this on the Kona N, but I think the handle is a standard Hyundai part, so it will probably work on other Konas and Hyundais.
Print it with the flat side down, no support needed. I used Eco-ABS with 0.1mm layers and 100% infill on a Dremel 3D45, because my Prusas were busy. But I think a wide range of printers, materials, and settings would work.
You will need two flathead screws, M6 x 16mm. This matches the exposed thread length on the original grab handle fasteners. You could probably use a screw as short as 8 or 10 mm and still make it work.