1 / 4
1.75mm Filament Welder and dryer No Post Proccessing (Designs) — zdjęcie 1
1 / 4

1.75mm Filament Welder and dryer No Post Proccessing (Designs)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Use a pen spring, PTFE tube, and a heat source to connect your 3d printing filament! Never waste spool ends again!

Ocena
5 / 5
Polubienia
85
Pobrania
622
Wydruki
10
Wyświetlenia
2528
Oceny
7

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Kategoria
Accessories
Licencja
Creative Commons — Attribution — Share Alike

Instructions as described by the original file maker (ZieLandy):

You will need A PTFE tube and coil spring.
-PTFE tube: Length: 40mm, 1.8mmx2.6mm
-Coil spring (Eg. From a ball pen)

Instruction of use:
Use a lighter or heat gun to heat the middle of the tube and spring. Push both sides of filament together as you do so. Keep the heat source there as you push the filament together from both sides, then remove the flame or heat source. Next, pop the side covers around the filament tube and push as hard as you can. This will act as a mold to ensure no deformities are present.

Due to the hot spring, it is normal for the pushers (mold/sides) to be damaged from its heat. They are needed to maintain consistent shape from the mold.


WHY DO YOU NEED A SPRING?
When you heat the PTFE tube, it softens. Two filaments are pushed in from both sides in that state, and the tube expands at the butted part. A spring is installed to prevent this expansion. Therefore, when you choose a spring, its inner diameter should be approximately the same as the outer diameter of the tube.

Cut the two filament ends at a 45 degree angle for best fusion results. This will ensure smooth adherence. 

Tagi