Fillament Drybox

Combined a bunch of others drybox designs to create my existing setup.

List of Purchased Parts:

• EZY Drybox 18L/19Qt from HomeDepot
• Metal Rod 5/16 x 36'' for Filament Spools also from Home Depot. I have a fine thredded rod but a smooth one woould be ideal.
• PTFE Connectors from AliExpress
  • Used a total of 9 PTFE connectors on my setup.
• PTFE Tube from AliExpress
  • Got the 2m since its cheap. Only used a little less than a meter in total.
• Humidity/Temp Sensor from AliExpress
• M3 Hardware Hex Screw from Aliexpress
  • Got the M3 282 piece kit.
  • 20x M3 3x10 screws (All used for the filament guides on the drybox and on temp sensor on the drybox)
  • 6x M3 3x20 Screws (Used on sillica case, 3 screws each)
  • All screw used with M3 Hex nut
• Fillamet Roll Bearings from AliExpress
  • 4x 608zz bearings for each roll, 16 total in drybox
• Sillica Gel from AliExpress

List of Printed Parts:

• Lack_Guide_Top/Bottom - Remixed Rimbalin's filament guide to be able to screw PTFE connector into it
  • Printed QTY: 1
• Bearing_Support - Used ReaperOfThresh's Bearing Support to better hold the spools in place while on the bearings
  • Printed QTY: 16
• Roll_Base - Used nameek's Filament Base to hold the rods that the spools are placed on.
  • Printed QTY: 2
• DryBox_Guide - Used Max Mustermann's filament guide to feed filament out of drybox and back in when roll is not in use.
  • Printed QTY: 16
• I designed a rough silica case, which is what im still using. Biggest flaw is where the screw holes are. Haven't had time to redesign.
  • Printed QTY: 4
• I designed the sensor holder
  • Printed QTY: 1

Print

• Printer: Prusa MK3S
• Fillament: Hatchbox Orange PLA
• Infill: 15%
• Supports: No