Heatpress idler wheel for 625Z bearings
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I didn't want to order another size bearing when building this so I remixed the top pulley to use 625Z bearings.
- Ocena
- 0 / 5
- Polubienia
- 9
- Pobrania
- 87
- Wydruki
- 0
- Wyświetlenia
- 419
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I honestly don't know where else I would end up using any 10x15x4mm ball bearings that the original heat set press model calls for, so I snagged one of the two bearings from these rollers that I had ordered for the project (easily popped out using a 12-13mm socket - and you end up with two bearings!
I personally skipped the M4 heatset insert and screwed directly into the holder with an M4x13mm hex head bolt.
You might need to scale the wheel up or down a bit depending on your choice of filament.
Printed here with Matterhackers Build PLA which was a snug fit :-)