AM4 Bracket adapter for XSPC Waterblock
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
I'm not sure what model this block is since I couldn't find it anywhere on the website. The block(with the stock…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 221
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Electronics
- Licencja
- Creative Commons — Attribution
I'm not sure what model this block is since I couldn't find it anywhere on the website. The block(with the stock bracket removed) is somewhere around 50x50mm. Should fit snugly. Print with relatively high infill and 4 shells minimum.
Take off the stock bracket with the 4 screws on top. My motherboard used 6/32 screws to attach the heatsink. You'll need longer ones I decided that 25mm was the right length but they only come in inch lengths so 1 in is fine. Make sure to tighten it in the cross pattern(corner to corner) to make it go.
Print Settings
Printer Brand:
FlashForge
Printer:
Creator Pro
Doesn't Matter
Supports:
No
Filament:
Who cares ABS or PETG
Notes:
Print in a higher temp filament. This part will have to withstand temperatures of up to 100C in the worst case without warping.
Category: Electronics