Tiny Keychain Micro SD Card Holder (for 2 cards)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Hello, this is a holder for 2 micro SD cards that can be attached to a keychain. It is printed in approx. 20 minutes.
- Ocena
- 4,727 / 5
- Polubienia
- 159
- Pobrania
- 901
- Wydruki
- 14
- Wyświetlenia
- 4177
- Oceny
- 11
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Office
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Hello,
this is a holder for 2 micro SD cards that can be attached to a keychain.
The holder snaps into place easily and is then securely closed. The tab on the side has a snall notch to make it easier to open the holder again.
I tried to make it as small as possible to reduce the likelihood of it getting tangled on a keyring or in your pockets.
The hole for the keychain has a diameter of 4 mm.
I recommend bending the joint manually after printing, so that it closes the holder properly later.
One important last thing:
I have a good gut feeling about the holder, but I have not yet been able to test it for a long time. So please don't use it to transport sd cards that you can't afford to lose!!! Thanks
Please leave a comment or shoot me a message if you like the holder or have any ideas how it could or should be improved. Thank you! :-)
If it does not work for you please leave a comment or shoot me a message instead of just posting a 1 star review, I'm sure there is no problem that can't be solved.
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Supports:
No
Infill:
40% Gyroid
Filament:
AmazonBasics PLA light Grey
Notes:
No supports needed.
I sliced it with 0.12 mm layer height in Cura.
Printing time is approx. 20 minutes
Category: Organization