Pi Zero 2 Mount for Prusa Mini Base
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Simple solution to securely mount the Raspberry Pi Zero 2 to the Prusa Mini Base mod.
- Ocena
- 5 / 5
- Polubienia
- 33
- Pobrania
- 112
- Wydruki
- 5
- Wyświetlenia
- 1861
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Prusa Parts & Upgrades
- Licencja
- Creative Commons — Public Domain
Just a case/mount solution to mount Raspberry Pi Zero 2 to the excellent Prusa Mini Base mod by David Warboss:
https://www.prusaprinters.org/prints/63483-prusa-mini-base
It uses the existing holes in the Mini Base rear right leg, so no modification to the base is necessary, ideal for octopi.
Requires 4 x M2.5 x 6mm screws to secure the top and bottom pieces, I've added 4 M2.5 nuts at the rear, but they're not critical, just dont over tighten.
Requires 2 x M3 screws to mount to Prusa Mini Base rear right leg, I used M3 x 20 as that's what is recommended to mount the filament sensor to the right front leg to the Mini Base.
Printed in PLA @ 0.15 layer height, but should work fine with most filaments and layer heights.
This is the original case:
https://www.prusaprinters.org/prints/84138-slim-raspberry-pi-zero-2-w-case
I've just made the bottom thicker for greater rigidity as the original bottom was very thin, and I've added screw holes as the existing model didn't seem very secure.