Monster Truck Grave Digger

THIS IS A FULLY PRINTABLE MONSTER TRUCK TO SCALE OF OTHER HOTWHEELS MONSTER TRUCKS. THE WHEELS MOVE TOO. Took a bit and a lot of Remaking parts so that it can print easier but the truck is finally done. Here's what ya gotta do.

For the top body piece, just add suports where supports should go and you should be fine.

For the frame, (I use a creality K1 and the "Creality Print" software), so Split the frame in half and lay both pieces flat on the print bed. Only supports needed are under the springs, but aren't techinically aren't necessary as I forgot to put them in the first place and they were pretty okay.

For the axil part, split it in half again where it's reasonable to do so, then glue the two halves together again. (No supports needed for me...depending how you want to go about slicing it.)

Then the wheels and axil parts: Self explanatory, no supports, just print them.

Lastly there's a file somewhere in there called "Piece to put ontop of frame if you want extra height (recommended)." Explanatory...

Finally, put all the parts together and you're done. If anyone actually reads these because I'm not expecting this model to blow up or anything, but, if you want another monster truck, leave a comment and maybe I'll make another body where you can just keep the same frame, axils, and wheels but swap out the body for a whole new truck. Just some thoughts, have fun or smthg.