Angled shotgun shell holder / side saddle (12 Gauge)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Angled shotgun shell holder in different versions (2 to 6pcs) for velcro fastening.
- Ocena
- 5 / 5
- Polubienia
- 125
- Pobrania
- 750
- Wydruki
- 2
- Wyświetlenia
- 3961
- Oceny
- 2
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Outdoor Sports
- Licencja
- Creative Commons — Attribution — Noncommercial
Special thanks to @sugarballs for the Idea!
Summary:
There are various version of this angled (15°) shotgun shell holder / side saddle available.
On the uploaded picture (Maverick 88) I used the 12G_5pcs_25mm_angled_velcro version. As Filament I used Prusament PETG with Carbon Fibers (Black).
Check the Key below to select the correct model for your shotgun:
| 12G_4pcs_25mm_angled_velcro | 12G = Caliber (12 Gauge) 4pcs = Capacity 25mm = Width angled = Shell direction/position velcro = Mounting |
Note: The angle is 15°.
Printing instructions:
Use PETG
Perimeters: 3
Solid layers Top & Bottom 5
Infill: >35%
No Supports
Note: Place the shell holder on the heat bed in the same direction as you would mount it.
Fastening:
Velcro Strip
(I used tesa On&Off extra strong)
Note: Use the “Loop”-side (German: Flauschband) on your gun and the “hook”-side (German: Haftband) on the holder. Btw: loop is the soft side, hook is the harder side of the velcro strip.
Outro:
The shell fit is quite tight and needs to wear in a little. Let me know about yours!
Happy printing and let me know if you need further information or instructions.