Angled shotgun shell holder / side saddle (12 Gauge)
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Angled shotgun shell holder in different versions (2 to 6pcs) for velcro fastening.
- Rating
- 5 / 5
- Likes
- 125
- Downloads
- 750
- Makes
- 2
- Views
- 3,961
- Reviews
- 2
Updated at source:
Model information
- Source
- Printables
- Category
- Outdoor Sports
- License
- Creative Commons — Attribution — Noncommercial
Special thanks to @sugarballs for the Idea!
Summary:
There are various version of this angled (15°) shotgun shell holder / side saddle available.
On the uploaded picture (Maverick 88) I used the 12G_5pcs_25mm_angled_velcro version. As Filament I used Prusament PETG with Carbon Fibers (Black).
Check the Key below to select the correct model for your shotgun:
| 12G_4pcs_25mm_angled_velcro | 12G = Caliber (12 Gauge) 4pcs = Capacity 25mm = Width angled = Shell direction/position velcro = Mounting |
Note: The angle is 15°.
Printing instructions:
Use PETG
Perimeters: 3
Solid layers Top & Bottom 5
Infill: >35%
No Supports
Note: Place the shell holder on the heat bed in the same direction as you would mount it.
Fastening:
Velcro Strip
(I used tesa On&Off extra strong)
Note: Use the “Loop”-side (German: Flauschband) on your gun and the “hook”-side (German: Haftband) on the holder. Btw: loop is the soft side, hook is the harder side of the velcro strip.
Outro:
The shell fit is quite tight and needs to wear in a little. Let me know about yours!
Happy printing and let me know if you need further information or instructions.