Swappable Bit Driver with Storage
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Swappable Bit Driver with Storage
- Ocena
- 0 / 5
- Polubienia
- 10
- Pobrania
- 24
- Wydruki
- 0
- Wyświetlenia
- 185
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I used organic supports with 0.3mm separation between model and part, I printed in silk PLA, but think that PLA+ or PETG would be superior. I used 0.3mm layers, but more detail would develop with 0.2mm layers.
Once printed use pliers to push and remove a swappable bit until it is easy to switch by hand. I use hemostats to remove supports. I then push them into the hole where the bit storage is and spin them around to debur edges. This should fit 4 bits comfortably. If there is an obstruction use an allen key to push through the anti-suction hole in the chuck side to remove the leftover support.
Note: Turn off extra perimeters & thick bridges if enabled to avoid the circular rings like in my print.