Swappable Bit Driver with Storage
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Swappable Bit Driver with Storage
- Rating
- 0 / 5
- Likes
- 10
- Downloads
- 24
- Makes
- 0
- Views
- 185
- Reviews
- 0
Updated at source:
Model information
- Source
- Printables
- Category
- Tools
- License
- Creative Commons — Attribution — Noncommercial — Share Alike
I used organic supports with 0.3mm separation between model and part, I printed in silk PLA, but think that PLA+ or PETG would be superior. I used 0.3mm layers, but more detail would develop with 0.2mm layers.
Once printed use pliers to push and remove a swappable bit until it is easy to switch by hand. I use hemostats to remove supports. I then push them into the hole where the bit storage is and spin them around to debur edges. This should fit 4 bits comfortably. If there is an obstruction use an allen key to push through the anti-suction hole in the chuck side to remove the leftover support.
Note: Turn off extra perimeters & thick bridges if enabled to avoid the circular rings like in my print.