1 / 4
Rails to slide Stanley organizer into IKEA TROFAST shelf
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Rails to slide a Stanley small parts organizer into an IKEA TROFAST storage unit.
- Ocena
- 0 / 5
- Polubienia
- 49
- Pobrania
- 153
- Wydruki
- 0
- Wyświetlenia
- 1793
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Organizers
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
SzczegółyPliki (3)Wydruki i komentarze (Wydruki: 0) (Komentarze: 0)Remiksy (0)Kolekcje (97)Powiązane
Overview
- Rails to slide a Stanley small parts organizer into an IKEA TROFAST storage unit.
- Each rail is split into two pieces (LHS/RHS) which snap together with a dovetail joint. This was necessary because my print bed (Prusa Mini) is only 18 cm^3.
Check this fits your gear
- IKEA TROFAST 46×30×H – Units come in two widths, you need the one which is 46 cm wide. The rows of holes in mine are spaced 127.5 mm apart, vertically.
- Stanley Pro organizer – Mine is 422 mm wide, and ~5.6 mm tall.
Parts required
You'll need three of each of the following, per rail:
- M4×10 threaded hex inserts (£1.18) – Screw these into the pre-drilled holes in the TROFAST unit
- M4×16 countersunk screws (£1.14)