Haldis 3D Red Lizard Q1 V6 Ender 3/CR-10/ Shroud and fan Duct
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
The default petsfang needed a lil modification to work with the red lizard q1 v6, i installed this on both my ender 3…
- Ocena
- 0 / 5
- Polubienia
- 0
- Pobrania
- 25
- Wydruki
- 0
- Wyświetlenia
- 292
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Printer Parts & Upgrades
- Licencja
- Creative Commons — Attribution
The default petsfang needed a lil modification to work with the red lizard q1 v6, i installed this on both my ender 3 and my cr-10 this was a great hot end! like all great hot ends make sure you properly install it/assemble or you will get leaks.
petsfang original - https://www.thingiverse.com/thing:2759439/
Print Settings
Printer Brand:
Creality
Printer:
Ender 3
Rafts:
No
Supports:
Yes
Resolution:
0.2
Infill:
80
Filament: any petg any
Notes:
follow the notes on the petsfang page for supports and speed.
basically limit speed to 40mm/s max travel at 100mm/s supports to 40 degrees 6 walls 80% infill
Category: 3D Printer Parts