1 / 3
BIQU H2 V2 - Ender 5 pro V2 BlowThrough mount (air duct raised) — zdjęcie 1
1 / 3

BIQU H2 V2 - Ender 5 pro V2 BlowThrough mount (air duct raised)

Zamów wydruk tego modelu

Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.

Zapisane na tym urządzeniu.

Blow through mount by JLCURTIS , remixed JakubFoltan's design to fit ender 5 pro

Ocena
4,5 / 5
Polubienia
7
Pobrania
38
Wydruki
2
Wyświetlenia
598
Oceny
2

Aktualizacja u źródła:

Informacje o modelu

Źródło
Printables
Licencja
Creative Commons — Attribution — Noncommercial

As JakubFoltan's mentioned, the Blowthrough mount's duct by JLCURTIS sat too low with the Biqu H2V2. I utilised JakubFoltan's design and lowered the H2V2 mounting hole by 2mm to raise the air ducts away from the print bed and shifted the cable management tie downs to the left hand side to suit my needs (wires too short).

As I have lowered the H2V2 by 2 mm, the z offset of the nozzle was too small for my liking (0.310mm). I have created a new mount for my CR Touch that lowered it by 1mm, giving it extra room. However, the stock BLtouch byJLCURTIS still works, just lower tolerance.

 

Print Settings

Printer brand: Creality

Printer: Ender 5 pro (stock)

Rafts: No

Supports: No

Resolution: 0.2mm

Infill: 10%

Material: eSun PETG

Tagi