Ender 3 pro Y motor mount (up to 60mm)
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
An Y motor mount for the Ender 3 Pro (and possibly v2) that supports longer motors up to 60mm
- Ocena
- 5 / 5
- Polubienia
- 16
- Pobrania
- 94
- Wydruki
- 3
- Wyświetlenia
- 469
- Oceny
- 3
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Creality Parts & Upgrades
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
I was unable to find a Y axis mount that supports 60mm motors, so I created this one. I tested this on the Ender 3 pro, and it might also work on the v2. I'm not sure whether there's any advantage to a 60mm motor over 48mm, but it can definitely provide greater acceleration than 32mm.
The mount installs onto the printer using M5 BHCS/SHCS screws, and the motor mounts with M3x30mm screws. For ease of assembly, I suggest pre-loading all four M5 screws onto the mount before installing it on the printer. The motor can only be installed after the mount is secured to the extrusion. No additional idlers or other hardware are required, except for a longer belt.
The pulley should be mounted on the motor shaft "upside-down", with the belt close to the motor body and the grub screw away from the motor.
I printed mine in ASA with 4 walls, but PETG would probably also work. I would not recommend PLA because the motor can get quite warm, and because PLA creeps over time.
Update: have a look here for an updated version of this design with double shear support: