1 / 5
GearUp Dice Thrower II
Zamów wydruk tego modelu
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This design reduces the size and print time of the previous Dice Thrower.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 14
- Wydruki
- 0
- Wyświetlenia
- 318
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Other Gadgets
- Licencja
- Creative Commons — Attribution
This design is based on my previous larger design that has a larger base. This design needs much less time to print than the previous one.
The gears were downloaded from McMaster Carr. The ratio of teeth between the gears is 60:15 (4:1). So, to turn the thrower gear 90 degrees, the larger drive gear needs to turn 1/4 as much, or 22.5 degrees (if my math is correct). Since there is a very small load, not much torque is needed to throw the dice as fast as you wish.