Raspberry Pi Zero 2 W Clipping Case for Prusa

This is Marius’ “Slim Raspberry Pi Zero 2 W Case” with a spacial backplate that can interlock on 3030 extrusion clips (themselves based on Shaun Doe’s “Prusa MK3 / MK3S / MK3S+ LCD cable clip“).

I’m using it to run a minimal Octoprint on a Raspberry Pi Zero 2 W. See images!

Includes:

• Backplate (back) case with female interlocks (01_backplate_interlock.stl)
• Twisting 3030 extrusion clips with cable passthrough:
  • With male interlock for the backplate (02_clip_wire_interlock.stl)
  • Without any interlock, to hold cables (03_clip_wire.stl)

Not included:

• Frontplate (top) of your choice from Slim Raspberry Pi Zero 2 W Case
• 4x M2.5 screws (M2.5x8 should be fine)

Print and assembly instructions

1. Print 1x backplate (01_backplate_interlock.stl)
2. Print 2x interlock clips (02_clip_wire_interlock.stl)
3. Print clips, as desired (03_clip_wire.stl)
4. Assemble the case (backplate, frontplate, 4x screws)
5. Attach the 2x interlock clips to the extrusion and snap-in the cables
6. Slide in the case over the interlock (adjust clips as needed)
7. Use extra clips to fasten cables along the extrusion