1 / 6
Raspberry Pi Zero 2 W Clipping Case for Prusa
Order a print of this model
We calculate the final price from your selected file. You review and accept it before payment.
Saved on this device.
Raspberry Pi Zero 2 W case with sliding clips for a 3030 extrusion (such as found on a Prusa), with cable passthrough.
- Rating
- 4.84 / 5
- Likes
- 190
- Downloads
- 733
- Makes
- 27
- Views
- 5,749
- Reviews
- 25
Updated at source:
Model information
- Source
- Printables
- Category
- Accessories
- License
- GNU General Public License v3.0
This is Marius’ “Slim Raspberry Pi Zero 2 W Case” with a spacial backplate that can interlock on 3030 extrusion clips (themselves based on Shaun Doe’s “Prusa MK3 / MK3S / MK3S+ LCD cable clip“).
I’m using it to run a minimal Octoprint on a Raspberry Pi Zero 2 W. See images!
Includes:
- Backplate (back) case with female interlocks (
01_backplate_interlock.stl) - Twisting 3030 extrusion clips with cable passthrough:
- With male interlock for the backplate (
02_clip_wire_interlock.stl) - Without any interlock, to hold cables (
03_clip_wire.stl)
- With male interlock for the backplate (
Not included:
- Frontplate (top) of your choice from Slim Raspberry Pi Zero 2 W Case
- 4x M2.5 screws (M2.5x8 should be fine)
Print and assembly instructions
- Print 1x backplate (
01_backplate_interlock.stl) - Print 2x interlock clips (
02_clip_wire_interlock.stl) - Print clips, as desired (
03_clip_wire.stl) - Assemble the case (backplate, frontplate, 4x screws)
- Attach the 2x interlock clips to the extrusion and snap-in the cables
- Slide in the case over the interlock (adjust clips as needed)
- Use extra clips to fasten cables along the extrusion