Blum Movento 629 Lock Drill Guide
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Guides a 2.5mm drill bit at the proper angle / spacing for the Movento (maybe other undermount) standard locking devices
- Ocena
- 0 / 5
- Polubienia
- 29
- Pobrania
- 154
- Wydruki
- 1
- Wyświetlenia
- 981
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Tools
- Licencja
- Creative Commons — Attribution — Noncommercial
I couldn't find the Blum drill guide I bought to use with the locking mechanisms of the Blum undermount drawer glides I was installing.
After checking Printables and not finding what I needed, I modeled this and printed it in a whole lot less time than Amazon would take to bring me another one.
The drill guide printed with PETG in less than an hour on my MK4.
It worked perfectly for my Movento 769 Soft Close slides.
The depth stop sleeve is for the 6mm x 10mm deep hole that captures the hook at the back of the drawer. To avoid any measuring, I set my drawers on the slides and push them back into the hooks, to make a dent in the wood where the hook hole goes.
Put the depth stop sleeve over the bit. Adjust the amount that sticks out to give the desired hole depth, then tighten the bit in place, making sure that one end of the sleeve is tight against the end of the chuck.
If you find this useful, or have feedback, please comment and leave a picture of your make.