Stand for 3D SETS Sakura 240 - Model 17
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
This support allows you to avoid having your tires flattened when your Sakura 240 remains unused for too long time.
- Ocena
- 5 / 5
- Polubienia
- 23
- Pobrania
- 130
- Wydruki
- 4
- Wyświetlenia
- 537
- Oceny
- 4
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- RC & Robotics
- Licencja
- Creative Commons — Attribution — Noncommercial — Share Alike
Warning
None.
Definition
None.
Printing
Is required the same printer size than 3D SETS has defined.
Infill 15% and layer 0.15mm is fine.
Build
- 4pcs. M3 x 6-15mm for top and middle part
- 1pcs. M3 x 6-15mm for middle and bottom part
Use the holes for the top/middle screws according to the weight distribution of your Sakura.
Feedback
It is welcome.
Remark
This modeling was carried out to meet a need of a 3D SETS Sakura 240 owner who validated this design. Big thanks to him.
Not owning the 3D SETS license for the Sakura 240, if upgrades were to be required, it will be difficult for me to do them without testing by a third party.
Version
v1/v20240505 1st upload.