Plug for Prusa - Prusament filament spool reduction
Obliczymy ostateczną cenę na podstawie wybranego pliku. Sprawdzisz ją i zaakceptujesz przed płatnością.
Zapisane na tym urządzeniu.
Reduction into Prusament filament spool for positioning the guide bearing - Placement of the spool on the guide rod.
- Ocena
- 0 / 5
- Polubienia
- 2
- Pobrania
- 17
- Wydruki
- 1
- Wyświetlenia
- 129
- Oceny
- 0
Aktualizacja u źródła:
Informacje o modelu
- Źródło
- Printables
- Kategoria
- Accessories
- Licencja
- Creative Commons — Attribution — Share Alike
For better unwinding of the filament, I constructed a holder that basically uses a 8 mm guide rod on which the spools are placed.
Since there is usually a rather large hole in the spools, I decided to create this reducer, a plug.
This particular reduction, the plug, is adapted to the Prusament coil - where the pin guide is also prepared.
The actual reduction then has a recess for a fixed location of the bearing.
Used bearing:
2 reducers and 2 bearings are needed to place on the rod
note:
The reduction on the photos are printed as:
- 0,4 nozzle
- PLA material
- first layer: 0,3 mm, 3 perimeters
- gyroid infil
- octagram spiral first and last layer